DPBISME said:Now if I can just get a parts list for a Keg and Carboy washer I will be Kicking@$$...
Unfortunately I'm on my phone and can't get a link easily but look up Marcb's Sanke Keg Washer build, it's blinged out but freaking awesome!
DPBISME said:Now if I can just get a parts list for a Keg and Carboy washer I will be Kicking@$$...
Now if I can just get a parts list for a Keg and Carboy washer I will be Kicking@$$...
This is super easy if you have the pump. Here's what you'll need:
That looks great, evancold!
How much were the grommets ultimately?
I was able to find them on ebay with free shipping. They were $8 per 20, I purchased 40 grommets for a total of $16 for grommets.
Great addition to Malfet's build with the grommets. Could you post a link where you found them. I could not locate anyone selling 20 packs.
I just want to confirm that PBW is the way to go, it doesnt work with oxiclean due to the foaming but PBW is just fine
Was this the 1-1/4" FIPS x 1" Slip adapter ($1.60 ea) you were looking for?revco said:This is super easy if you have the pump. Here's what you'll need: (1) 1-1/4" Lead Free Brass or SS Coupler (1) 1-1/4" to 1" Lead Free Brass or SS Reducer Bushing (1) 1" MIPS to Slip CPVC Adapter (Note, the three above parts can be replaced if you can find a CPVC 1-1/4" FIPS x 1" Slip Adapter, I haven't found any personally.
So I was able to make this finally and it works great!
I followed Nameless's version of this bottle washer as I use the fastrack. I must say it makes this process even easier when you use the fastrack. I did not make posts like you design did but surprisingly enough the posts are not necessary. water still makes contact with the bottom of the bottle at all times. I used the same pump that you recommended and instead of placing the bottles inside the crate, I put them on top of the crate to elevate them.
I cut notches into the fastrack feet so the rack literally just fits into place and does not move. It only takes a few minutes and all 24 bottles are fresh and clean!
Thanks for the great ideas, Ill post later if I have any updates.
I cycle from Oxyclean to clean water to StarSan.
Hey man, I just built this unit but out of PVC. What size holes did you use in your copper?
Enter your email address to join: