DevilsCups
Well-Known Member
Great, this saves me some headache. Thank you!I’ve been running mine like this with no issues. I think the important thing is no sharp bends and make sure the end of the hose never gets submerged.
Great, this saves me some headache. Thank you!I’ve been running mine like this with no issues. I think the important thing is no sharp bends and make sure the end of the hose never gets submerged.
Not a bit. You might be overthinking it... Can you try it without the extension and see how it goes, then buy it later?Not sure if that would cause any issues with effectiveness.
Hmmm. I need an extension of some sort due to the nature and shape of the steam hat from Brewtools. The condenser tee will bottom out on the domed lid without an extension. It's more a matter of how long an extension I need to be able to dump to the sink effectively without having to go into a bucket.Not a bit. You might be overthinking it... Can you try it without the extension and see how it goes, then buy it later?
Don't forget that at some point it'll hang so far off that the lid will want to lift up on the opposite side and have the whole thing tip over.
Yeah, sorry, that's what I was trying to say. Get it over the edge of the kettle / use what you have (assuming what you have gets it over the edge of the kettle already), and then let the hose do the rest.It's more a matter of how long an extension I need to be able to dump to the sink effectively without having to go into a bucket.
All good! My old setup was mounted on the side of my kettle, so no extension. I think the 12” is in order for me. I’ll keep the thread posted once I give it a test run!Yeah, sorry, that's what I was trying to say. Get it over the edge of the kettle / use what you have (assuming what you have gets it over the edge of the kettle already), and then let the hose do the rest.
You know, I was wondering if it functioned like that. Really happy to hear it does!Your going to.like that lid, it's a game changer..once the vacume gets established, the viewing window is clear.
Enter your email address to join: